First Course Of Bevel Siding

Installing bevel siding clapboards spacing for the siding should be laid out beforehand.

First course of bevel siding.

It is normally blocked out with a starting strip the same thickness as the top of the siding board see figure a. Set the first bevel board in place against the trim at a corner of the house. Bevel siding also referred to as clapboard siding is a very popular wood siding product. One edge has a thick butt while the other edge is thinner.

Make sure the first course is level. Nail the clapboard to the studs. On rabbeted bevel siding leave a 1 8 inch expansion clearance. Step 8 siding beside windows photo by david carmack.

If more than one clapboard is needed to span a wall snap a chalk line between the marks on the corner boards on top of the course being overlapped. Bevel wood siding provides rustic warmth for homes and log cabins. The manufacturing process results in pieces with one face saw textured. Align the bottom of the bevel plank with the bottom of the starter strip with the end flush against the trim and.

Start with the bottom course using a furring strip to support the lower edge. The dolly varden rabbeted bevel profile is an easier install while providing the same traditional bevel style and appearance. Fasten bevel siding in place using one nail per bearing or stud spaced a maximum of 24 inches on center. Siding should be nailed to each stud or on 16 inch centers.

Clapboards have a triangular cut. Siding may be installed starting with the bottom course. With dolly varden siding you get the appearance of bevel and clapboard siding but the convenience of self spacing thanks to the rabbet at the bottom to accept the top of the preceding course. It is lumber that has been resawn at an angle resulting in two pieces.

Place the nail just above the overlap. It is produced by resaying lumber at an angle to produce two pieces thicker on one edge than the other. Thinner at the top and wider near the lower more exposed part of the board. The number of board spaces between the soffit and bottom of the lowest piece of siding at the foundation should be such that the overlap is as per the table.

For bevel siding this is a minimum of 1 inch. Join the clapboards with scarf joints as in step 3. The rabetted bevel dolly varden pattern features a 1 2 3 4 notch in the thicker butt end of the board this rabbeted edge cut allows the bevel siding panels to fit together in such a way as to protect joints from water infiltration. When installed it is nearly impossible to tell the difference between dolly varden and bevel or clapboard siding.

This is the first of a 2 part series. Click here to read a short course on cladding part 2. Carefully slide the notched piece of siding into place. The most familiar type of wood siding is the clapboard a form of lap siding that s also called bevel siding.

They are lapped to shed water.