Deck Ledger Installed Over Siding

These 18 articles will teach you how to install flashing and bolt the ledger connection to the house rim.

Deck ledger installed over siding.

I want to attach the ledger board directly into. Never install a ledger on top of house siding. If the rigid foam is only 1 2 inch thick and the wall sheathing is only 1 2 inch thick then the deck ledger can still be installed directly over the sheathing without any additional work per irc table 507 2 referenced above. Properly installing a ledger board for your deck is one of the most important structural components of building a safe and strong deck.

Here is a picture of the portion of the deck i want to extend add on to. Deck framing connection guide page 7 ledger attachment ledger may not be installed over siding or stucco. It must be fastened directly to the rim joist or stud or through sheathing into an appropriate framing member. The siding is either steel or aluminum not sure how to tell the difference easily.

The wall leg is at least 7 in. Never install a ledger board over the top of siding no matter what you hear this can weaken the connection. The only way to determine if there is an inset rim joist is to probe with a drill bit before mounting the ledger. Start by making an outline on the siding where you want to position the ledger board.

It only weighs 100 pounds it is a ledger board a front plate and eight 2x4 rafters sitting on two 4x4 posts. Then cut away the siding. Looking at the existing deck it appears that they install the ledger by bolting it over the siding of the house rather than removing the siding and properly flashing. The ledger is a header that transfers the weight of the deck to the framing and foundation of your house.

Run flashing behind the siding and over the ledger as should have been done in the first place. In order to install the ledger board you usually need to remove the house s siding. I m installing a small trellice roof attached onto the side of my garage. Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.

This is extremely dangerous and does not offer. Cut back the siding above the ledger in two places right at the top of the ledger and 1 above the level of the board that goes over the ledger. Loosen the siding left above the ledger so that you can slip flashing under the paper under the siding. This may seem excessively tall but is needed in order for the water resistive barrier wrb and siding to overlap the top.

It is for having a potting bench and some gardening tools under. Nail undersill trim j channel will also work over the bottom cut using 11 gauge aluminum nails.